1.
Filling the Cracks
One last point on filling cracks - It has been recommended to fill large cracks by gluing in small slivers cut from strips. I suppose that would work, ...
2.
John Michne's Boat Building Stuff
At Last! The long wait is over -. our book is finally here! Book Info · Web Site Home.
3.
Making Accent Stripes
Making accent stripes which are a little more complex than a single strip that contrasts with the basic hull color is not difficult, but it does take some ...
4.
Making Accent Stripes
Making accent stripes which are a little more complex than a single strip that contrasts with the basic hull color is not difficult, but it does take some ...
5.
Building the Wee Lassie II
For the Wee Lassie II, I built a framework out of 1 x 4's and screwed them to the forms in the problem areas. Then I clamped some 1 x 2's to the vertical ...
6.
Fiberglassing - 101
Fiberglassing - 101. Rev. August, 2003. If you have never done it, the most daunting job in building a boat can be that first time you put on fiberglass. ...
7.
Making Stems
One exception is gluing on an outer stem, where the ends of the cedar strips are all or part of the gluing surface. Cedar absorbs epoxy quite readily, ...
8.
Making Accent Stripes
If the strips to be used were 3/4" wide with bead and cove edges, little solid stock for cutting and cleanup would remain. I don't like to do this, ...
9.
John Michne's Boat Building Stuff
At Last! The long wait is over -. our book is finally here! Book Info · Web Site Home.
10.
Fiberglassing - 101
The end grain had more, but still not enough to ever cause problems while fiberglassing. Now, it is often stated, and mistakenly so, that the heat generated ...
